Hi, I have upgraded to version 5.0.1, and to DBG ver. 3.2.3

After that I noticed, that 'Step Over' command works in the same way as 'Step In', so I need to use 'Run to cursor' command step over function calls.

it worked correctly in previous version.

Can you please look into this problem, thanks.

I know this does not solve your problem, but I thought I should confirm that "step over" works fine for me in build 5029. It is likely an issue specific to your setup, and probably best to open a support ticket.

Could you please provide some details about your system - php version, webserver and OS please? Thanks!

Here is some details

PhpED 5.0.1 (5029)
Windows XP SP2

Webserver:
Apache/1.3.37 (Unix) with PHP/4.4.4
DBG version 3.2.3

Debug mode: 3rd party webserver.

When I dubug using internal PhpED webserver all works fine.
it seems problem caused by DBG module in my webserver.

I just tried php 4.4.4/dbg 3.2.3/Apache 1.3.31 and step-over worked fine.
BTW, do you press F8 or F7 or buttons on the toolbar? It may appear that you have changed the shortcuts by mistake.

Thank you for your reply.

I checked shortcuts and also tried to use both buttons and shortcuts, step over on my system still works incorrectly with 3rd party unix webserver as I said prevous version of PhpED/DBG worked fine. Can you suppose what may caused such problem, at least the problem is in IDE or in DBG module. It is possible that problem is in my particular configuration, but I want to figure should I examine my Unix webserver/php config or may be try to reinstall IDE.

Thanks a lot.

Do you have any other non-standard php extension or zend_extension loaded on that server? If so, try to comment them all off.