NuSphere Forums Forum Index
NuSphere Forums
NuSphere Forums Forum Index » PhpED PHP IDE        RSS2 Feed
Reply to topic
run command (trial is over)


Joined: 17 Feb 2006
Posts: 9
Post Posted: Wed Jul 05, 2006 12:43 pm Reply with quote
I had to reinstall php ed.
After doing so I have complete lost the ability to use the run or run with debugger command.
I am just using the local srv webserver that was installed with php ed.
I can get to a page by going to ie or firefox and typing localhost:8080 and my pages will run.
Any suggestions?
View user's profileFind all posts by AugSend private message
Site Admin

Joined: 13 Jul 2003
Posts: 8340
Post Posted: Wed Jul 05, 2006 5:02 pm Reply with quote
Dear Andrew,
You started using PhpED trial version on June 13, 2006 and therefore the evaluation time is over by now. That's why those commands are not available anymore.
View user's profileFind all posts by dmitriSend private messageVisit poster's website
run command (trial is over)
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
 		All times are GMT - 5 Hours  
Page 1 of 1  
  
  
NuSphere Forums Forum Index » PhpED PHP IDE
 Reply to topic