NuSphere Forums Forum Index
NuSphere Forums
Reply to topic
encoding in dialogs *solved*


Joined: 21 Dec 2005
Posts: 9
Reply with quote


I am losing letters due to encoding. I am using czech QWERTY keyboard but this should not be an issue. So far encoding support for files (utf etc.) is OK Very Happy but dialogs are wrong Question . Which font is used for dialogs?

I tried Appearance and IDE settings - font settings but these are not related to dialogs.
Thanks for advice.
View user's profileFind all posts by motokSend private message
Site Admin

Joined: 13 Jul 2003
Posts: 8342
Reply with quote
Check if Windows Control Panel -> Regional and Language Options -> Advanced contains "Czech" in the combobox. If not, please select it and if asked to reuse installed Fonts - do not agree and install them from the Windows CD again.
Hope it helps.

That input you asked about uses "MS Sans Serif" font.
View user's profileFind all posts by dmitriSend private messageVisit poster's website


Joined: 21 Dec 2005
Posts: 9
Reply with quote

Very Happy

That's amazing, it shows two things. I don't use czech as much as I thought or most programs that I have use unicode Laughing
Thanks ddmitrie!
View user's profileFind all posts by motokSend private message
Site Admin

Joined: 13 Jul 2003
Posts: 8342
Reply with quote
I know MS Sans Serif actually is not a good font for unicode applications, that's why you'd have appropriate MS Sans Serif font installed that has all Czech symbols in your case. The only workaround I found is what I suggested before.
View user's profileFind all posts by dmitriSend private messageVisit poster's website
encoding in dialogs *solved*
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT - 5 Hours  
Page 1 of 1  

  
  
 Reply to topic