NuSphere Forums Forum Index
NuSphere Forums
Reply to topic
cursoring Y should position cursor at same X place


Joined: 28 Jun 2006
Posts: 92
Reply with quote
I have cursor past EOL disabled, so when I move cursor vertically line by line, my cursor naturally jumps to the end of the next line. However, when the cursor hits a line that allows for the cursor to get as far as it was where I started, it should go there (not stop at the farthest left point that it could).
View user's profileFind all posts by bcswebstudioSend private message
cursoring Y should position cursor at same X place
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
All times are GMT - 5 Hours  
Page 1 of 1  

  
  
 Reply to topic